• With profiled steel rails and tempered cast tensioning arms• Colour may vary on the clamp from red to yellowPDF Catalogue Page

For routing 530 x 430 mm apertures for Belfast sinksFitting instructions includedCraft papers bound with phenolic resin and laminated with a melamine ...

• 5 m/16 ft and 8 m/26 ft lengths, 19 mm (5 m tape) and 25 mm wide (8 m tape), metric and imperial reading• Class II accuracy• Forwa...

For upgrading the DBB mortice jig from the old snap-on cutters to the new screw-on versionSupplied with1x Standard screw-on shaft: 220 mm length (for ...

With lasered scale for aligning the insert platesExact, dimensionally accurate drilling with the depth gauge systemInterchangeable drill guides allow ...

For routing apertures for sinks and hobsIncludes: Left and right hand radius curves at 100, 80, 60 and 40 mm, left and right hand 90 degree angles, st...

• To suit 76 mm thick doors• Comprises universal base plate and set of slot-in templates packed in a carry case• Cabinet set compris...

Screw on shaft designSteel298 mm long shaftDepth of mortice cut: 180 mmOrder referenceJigs, cutters and accessories to be ordered separatelyPack size1...

The jig allows for an inset distance from the front carcase edge of 37 mm and from the back edge of 69 mmIntegral sliding positioning tabs ensure cons...

Depth gauge with drill bit suitable for Hafele Red Jig drilling jig Variantool dig for series drilled holesDrill bits are pre-set to drilling depth 13...

• Patented tooth grind• Double ground• 7 teeth per 25 mm PDF Catalogue Page

• Galvanized steel

For Red Jig drilling jig 001.25.600 (see Related Products below)For use with depth gauge 158.0 mm shaft diameter130.00 mm total length1/4" hexagon chu...

Exact, dimensionally accurate drilling with the new depth gauge systemInterchangeable drill guides allow quick drilling pattern changesCoordinated wit...

Free Swing Drilling JigFor Free Swing stay flap systemsAcrylic glass with hardened steel insertsPack size1 piecePlease order 5mm diameter self centeri...

• Straight, two flute• Shaft Ø: 1/2" / 12.7 mm• Tungsten carbide tipped PDF Catalogue Page

For right and left standard 90 and 45 degree jointsFor right and left 90 degree joints where walls are up to 1.5 degree out of square (28 mm over 1 m ...

Area of applicationFor restricting the drilling depth, for standard and long shaftsOrder referenceJigs, cutters and accessories must be ordered separa...

For use with worktop jig 002.13.565/566 (see Related Products below)Set comprises 4 black plastic pegsPack size1 pack (4 pegs)Online Catalogue